Navigation:  Calculation Modules > Analysis > ENERCALC 3D > Ribbons > Create > Draw Loads > Nodal Loads

Create > Draw Loads > Nodal Loads prompts you with the following dialog.  

 

 

 

It allows you to assign nodal loads to selected nodes in the model.  You must select a load case to which the nodal loads belong.  Nodal loads are specified in the global coordinate system.  The loads are nodal forces in the X, Y, or Z direction if radio button “X”, “Y”, or “Z” is selected.  The loads are nodal moments in the X, Y, or Z direction if radio button “OX”, “OY”, or “OZ” is selected.  The load magnitude may be any non-zero value.