Navigation:  ENERCALC SEL > Project Manager > Wind, Seismic, and Snow Load Modules

Where did my wind, seismic, and snow load modules go?

 

Recent builds of ENERCALC have seen a subtle organizational change to the Project Manager...the introduction of the LOADS & FORCES Division.

 

This was done partly for organizational purposes and partly to set up ENERCALC SEL to receive many scheduled enhancements in the area of load and force calculators.

 

So if you're looking to use the ASCE 7 Wind or Seismic modules, or if you're looking for the new IBC 09 Wind or ASCE 7 Snow Loads module, just expand the LOADS & FORCES Division and you'll find them all organized right there for you.