Skip to content
For the complete documentation index, see llms.txt. This page is also available as Markdown.

Nodal Loads

How to apply nodal forces and moments in global directions to selected nodes by load case.

Create > Draw Loads > Nodal Loads prompts you with the following dialog.

It allows you to assign nodal loads to selected nodes in the model. You must select a load case to which the nodal loads belong. Nodal loads are specified in the global coordinate system. The loads are nodal forces in the X, Y, or Z direction if radio button “X”, “Y”, or “Z” is selected. The loads are nodal moments in the X, Y, or Z direction if radio button “OX”, “OY”, or “OZ” is selected. The load magnitude may be any non-zero value.

Last updated

Was this helpful?